Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   General information
   Forward brakes
   Back brakes
   Back disk brakes
   Main brake cylinder
   Pumping of brakes
   Brake amplifier
   Adjusting valve
   Hand brake
   Adjustment of brakes
   Anti-blocking system (ABS)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices



Hand brake

The brake amplifier in a case with the established ABS system

1 — a nut, 8-11 N • m
2 — the brake amplifier
3 — шплинт

4 — a finger шплинта
5 — a nut, 13-16 N • m

Arrangement of cables of the hand brake

1 — a back cable
2 — a bolt, 3.5 - 4.5 N • m
3 — a bolt, 3.5 - 4.5 N • m
4 — a bolt, 8-11 N • m
5 — the lever of the hand brake
6 — a forward cable

7 — a bolt, 3.5 - 4.5 N • m
8 — a bolt, 3.5 - 4.5 N • m
9 — a back cable
10 — a bolt, 8-11 N • m
11 — the cable end, drum-type brakes
12 — the cable end, disk brakes

Replacement of a forward cable of the hand brake

On an illustration the arrangement of both cables of the hand brake, and also fastening of a forward cable on the lever of the hand brake is shown. At replacement of a cable be guided by this illustration.

 PERFORMANCE ORDER

  1. Lift the car and establish on support.
  2. From the bottom party remove two nuts of both cables and unhook both terminal elements of cables from the leveling lever.
  3. Remove the switching console.
  4. Disconnect the tip of a cable of an alarm lamp of the hand brake.
  5. Weaken bolts of fastening of the lever of the hand brake and unscrew the holder of a forward cable.
  6. Take out a cable.
  7. Installation is carried out in return to sequence removal. Cock the lever of the hand brake and bolts of cables on the bottom with the set moments.
  8. Strengthen cables according to an illustration. All elements of sliding of a cable of the hand brake well grease.

Replacement of back cables of the hand brake

 PERFORMANCE ORDER

  1. At the established drum-type brakes unhook cables of the hand brake from brake shoes as it was described at removal and installation of blocks in the Section Back brakes. Then to make removal according to an illustration.
  2. At the established disk brakes remove fastening and a lock plate on a back support (see an illustration) and then remove cables according to an illustration.
  3. Installation is carried out in return sequence. All moments of an inhaling given on an illustration should be sustained. Not all bolts have the identical moment of an inhaling.