Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
- Manual transmission, differential and main transfer
   Transmission and differential - the general information
   Removal and transmission installation
   Transmission partition
   Gear shifting mechanism
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices



Gear shifting mechanism

Removal and installation of the lever and switching bar

Details of the mechanism of switching on outer side of a transmission

1 — the handle of the lever of switching
2 — a dustproof casing
3 — directing the switching lever
4 — the switching lever
5 — the top support of the lever of gear shifting
6 — plugs
7 — consolidation of round section
8 — a dustproof nozzle
9 — a nut, 0,5 - 0,6 Nanometers
10 — rubber laying
11 — a frame of a support of the lever of switching
12 — a damper, only on the injector engine

13 — the holder
14 — a nut, 12-15 Nanometers
15 — a nut. 12-15 Nanometers
16 — an elastic band of a returnable spring
17 — a returnable spring
18 — a nut, 22-30 Nanometers
19 — a stabilizer bar
20 — a bolt, 37-50 Nanometers
21 — a nut, 14-18 Nanometers
22 — a switching bar
23 — a nut, 18-24 Nanometers


 PERFORMANCE ORDER

  1. Weaken a dustproof cover round the lever of switching and remove it from the lever up.
  2. Put round a head of the lever of switching a thick rag and unscrew a head by means of nippers for the water pump. Watch, that blocks of nippers did not damage a lever head.
  3. Lift the car and unscrew from the bottom party a bar of switching and a basic level sideways transmissions (see an illustration).
  4. Remove four bolts and nuts of a support of the lever of switching (the illustration is lower) and remove all support with the bars located on it.
Fastening of a support of the lever of switching on the bottom party of the car.
  1. Installation is carried out in return sequence. It is necessary to observe all moments of an inhaling specified illustrations. The support of the lever of switching is fixed by nuts on the bottom party of the bottom.

Replacement of details of the mechanism of switching

On an illustration assembly diagram of the block of switching is represented. If it is required to replace any details, it is possible to use an illustration. At assembly grease all details with a small amount of greasing. It is necessary to replace all consolidations of round section, even if they still have satisfactory appearance.