Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   General information
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks - the general information
   Fusible inserts (thermal relays) - the general information
   Chain breakers (thermal relays) - the general information
   The relay - the general information
   Headlights
   Explanatory remarks to schemes of electric connections
+ Appendices



Safety locks - the general information

1 — the Suitable safety lock
2 — Fused

Protection of electric contours of the car is provided with application of a combination of safety locks, breakers of a chain and fusible inserts. The burned-down safety lock is easy for distinguishing from serviceable by survey of its transparent plastic case. Attentively examine a safety lock about identification of its peregoraniye. If the safety lock outwardly looks normally, but suspicions on its malfunction remained, make conductivity check between the knife plugs acting from its case.

At replacement of safety locks watch compliance replaceable old on type. The safety locks calculated on a various current can outwardly look identical therefore it is necessary to give special attention to marking. Replacement of the burned-down safety lock on calculated on smaller - and especially big - a current is undesirable. Each electric contour needs different extent of protection. Watch that marking on the case of a safety lock corresponded to a current on which the corresponding contour is calculated.

If the replaced safety lock immediately fuses, it is not reasonable to continue its replacement. Before it is necessary to reveal and eliminate the reason of its knocking-out. In most cases that appears short circuit of electroconducting of the contour, caused by break or damage of isolation of a wire.